 |
||||||||||||||
 |
|
|||||||||||||
 |
||||||||||||||
 |
|
|||||||||||||
 |
 |
 |
|
|||||||||||
|
||||||||||||||
|
|
|
|
|
|
|
||||||||
ENDING YOUR SESSION1. Move the stage until the cross hairs are on the brass part of the standard block. 2. Unblank the beam. 3. Turn off the Beam Current Regulator (push out REG ON, then push out BCR MODE).
4. Turn off the Backscattered Electron Detector if being used. 5. Turn off the SEM Display if being used. 6. Turn off the X-RAY Amplifier
7. Set light to Reflected light. 8. Turn the Filament Voltage down to zero.
9. Step the Coarse kV down to zero.
10. Turn the Electron Gun Power Supply off.
11. Step Coarse kV up to five.
12. Turn off the lights and lock the doors. Make sure the back door is shut tightly. |
|||
on the SEM Console.
on the X-RAY Console.
on the Electron Gun Supply Console.
on the SEM Console.
on the Electron Gun Supply Console.